If you want to perform an installation of glass blocks, with the aid of mortar, then give them some useful tips for the development of such work.

Installation of glass blocks

First. You have to adjust where you place the spacer block. Ideal cut with scissors for sheet-shaped spacers in the form of L and T. This is to avoid making arrests when this using the mortar.

Second. It’s good to have a schedule to follow what you want. Prepare the panel brackets are fixed to the uprights and the lintel by screws. When using fasteners ideal is to use plastic anchors. Expansion strips are cut according to measure the brackets where they are located. Once cut you have to insert between the blocks, the jambs and the lintel. This allows the joints are watertight.

Third. The mortar used must have good consistency. He proceeds to cut the wire to reinforce the installation applying it to all brackets horizontal rows. Mix the mortar and avoid contact with eyes and skin to avoid irritation. It is distributed as a layer whose thickness depends on the process. The spacer are incorporated in the corner L and T at the distance of a block of the opening, to proceed to apply the mortar.

Fourth. One of the blocks should be without mortar, to place the tiara of expansion. Repeat the process until the spacers cut exhaust. We proceed to check the horizontal level support. Using the rubber brush pressure is reintroduced to the mortar over the joint. This process must be left to dry as directed by the manufacturer of the mortar, to obtain good results.

For the work is clean is important to remove the waste block with the help of a non-abrasive cleaning compound. Installation of glass blocks is ideal to apply the mortar joints on a layer of clear acrylic or silicone sealant, in order to prevent mold.

Installation of glass blocks without mortar

The equipment to be used in an installation of glass blocks without mortar can vary by manufacturer. Generally these include metal or plastic channels, which surround the panel and interlocking spacers between the blocks. Know that this type usually requires media wall on 4 sides.

In the market there are acrylic blocks if the weight of glass is a drawback. These panels should be assembled and mounted on a permanent basis, either by means of a sealant or glue. The steps are:

1. Prepare the opening.
2. We performed a test installation.
3. Channels are fixed to the uprights junction at the bottom and top.
4. To set screws can be used.
5. They paint the screw heads with the intention that they are not in the blocks.
6. Blocks are assembled glass spacers that intersect.
7. It incorporates the sealant to joints.
8. Joints are smoothed.

Happy Installation of glass blocks with mortar.